▪ DST Offset: Click the drop-down list to set the time offset
based on respective time zone.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
SSL
Enable HTTPS/SSL (Secure Socket Layer) management access
System > SSL By default, your switch management page can be accessed using standard
web HTTP protocol which is unsecure. Enabling HTTPS/SSL management access allows
access to the switch management page using secure encrypted communication which
prevents unauthorized users from intercepting user name and password credentials.
Typically, the switch is accessed within the local network only by system administrators
which does not necessarily require additional security. It is recommended to only enable
this feature, if allowing switch management access from other networks or over the
Internet.
Note: Once HTTPS/SSL management access is enabled, HTTP management access will be
disabled forcing all access to the switch management page using secure encryption
communication only.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on System, and click on SSL.
3. Review the settings. Click Apply to save changes.
• SSL Status:
o Enabled – Enables HTTPS/SSL management access and disables HTTP
unsecured mode.
o Disabled – Disabled HTTPS/SSL management access and enabled HTTP
unsecured mode. (Default setting).
If enabling SSL management access, you will need to access the switch management
page using HTTPS instead of HTTP. (e.g. https://192.168.10.200)
To Next Page
Loading...
Need help?
General