Error
System > Statistic > Error
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on System, click on Statistics, and click on Error.
3. View the Error Information Statistics.
• InErrors: Inbound Errors (Pkts), number of inbound errors in packets per second.
• OutErrors: Outbound Errors (Pkts), number of outbound error packets.
• DropEvents: Drop Events, number of packets dropped.
• CRCAlignErrors: CRC and Align Errors, number of CRC and Align errors that have
occurred.
• UndersizePkts: Undersize Packets (Pkts), number of undersized packets (less
than 64 octets) received.
• OversizePkts: Oversize Packets (Pkts), number of oversized packets (over 2000
octets) received.
• Fragments: Number of fragments (packets with less than 64 octets, excluding
framing bits, but including FCS octets) received.
• Collisions: Number of collisions received. If Jumbo Frames are enabled, the
threshold of Jabber Frames is raised to the maximum size of Jumbo Frames.
• Apply: Click the Apply button to clear port specific Traffic information.
• Refresh: Click the Refresh button to update table with newest traffic
information.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
To Next Page
Loading...
Need help?
General