Guidelines 141
Chapter 4 Installation and Maintenance
If you physically change an I⁄O bus address, you should:
• Cycle power or re-install the module
• Change the TriNode address in the TriStation project
MP Baseplate Addressing
The address plug on the MP Baseplate identifies the TriNode address used by
TriStation. The TriNode address specified in TriStation must match the address on
the MP Baseplate. Each controller on a network should have a unique address on
its MP Baseplate.
If you physically change an MP Baseplate address, you should:
• Cycle power or re-install the module
• Change the TriNode address in the TriStation project
To Next Page
Loading...