Factory Mutual 19
Chapter 2 International Approvals
Factory Mutual
Factory Mutual verifies the controller for use in Class I, Division 2 Temperature
T4, Groups A, B, C, and D hazardous indoor locations in compliance with the
following standards.
Test Report
Certification is pending. For test report status, please contact the factory.
Standard
Number
Title
3611 Electrical Equipment for use in Class I
—Division 2; Class II—
Division 2; and Class III—Divisions 1 and 2, Hazardous Locations
3810 Electrical and Electronic Test, Measuring and Process Control Equipment
3600 Electrical Equipment for Use in Hazardous (Classified) Locations
—
General Requirements
To Next Page
Loading...