236
Trident Planning and Installation Guide
Invensys Process Systems
15345 Barranca Parkway
Irvine, Ca 92618 USA
EU-Declaration of Conformity
The EU Directives covered by the Declaration
89/336/EEC Electromagnetic Compatibility Directive, amended by 92/31/EEC & 93/68/EEC
72/23/EEC Low Voltage Equipment Directive, amended by 93/68/EEC
The Products Covered by this Declaration
Trident (Triple Modular Redundant Controller) Version 1.1 – 2101, 2201, 2301, 2351, 2352, 2381, 2401,
2451, 2481, 3101, 3201, 3301, 3351, 3381, 3401, 3451, 3481, 3482, extender modules, and I/O bus cabling
The Basis on which Conformity is being Declared
The product identified above complies with the requirements of the above EU Directives by meeting the
following standards:
1. EN 50081-2:1993 EMC – Emissions
EN 55011:1998 Gr. 1 Kl. A Conducted and radiated
2. EN 61131-2:1994/A11:1996 EMC – Immunity
EN 61000-4-2:1995/A1:1998 ESD
EN 61000-4-3:1996 Radiated HF fields
EN 61000-4-4:1995 Burst
EN 61000-4-5:1995 Surge
PrEN 61000-4-12:1994 Ringwave
3. EN 61131-2:1994/A11:1996 Product Safety
EN 61010-1:1993 Overvoltage Category II
The technical documentation required to demonstrate that the product meets the requirements of the above
directives has been compiled by the signatory below and is available for inspection by the relevant
enforcement authorities. The CE mark was first applied in: 2000.
Special Measures and Limitations which must be Observed
The product must be installed and operated as described in the Trident V1.2 Planning & Installation Guide.
The products described above comply with the essential requirements of the directives of the directives
specified.
Signed:
Scott Miller, Vice President Technical Programs, Invensys Process Systems
To Next Page
Loading...