4 Software
Personal settings
1. In the Personal settings panel, tap Reset. The Settings dialog appears.
2. Tap OK. The following settings are reset to the default values.
l l The current unit for Length, Angle, Temperature, and Pressure resets to Meters, Degrees,
Celsius, and mbar.
l The Full scan's mode resets to Level 1.
l The Area scan's mode resets to Level 1.
l The last Operator Name resets to blank.
l The PPM value resets to zero.
l The Pressure value resets to 1013.25 mbar.
l The Temperature value resets to 20 °C.
l The last diagnostics test date.
3. Tap OK again.
Trimble TX8 3D Laser Scanner User Guide 91
To Next Page
Loading...