GENERAL INFORMATION
92
▼ Align the seat lock peg to the lock
and press down, engaging the seat
lock. An audible click can be heard
when the seat is fully engaged in its
lock.
WARNING
To prevent detachment of the seat
during riding, after fitting always
grasp the seat and pull firmly
upwards.
If the seat is not correctly secured in
the lock, it will detach from the lock.
A loose or detached seat may lead to
loss of motorcycle control which could
result in serious injury or death.
▼ Grasp the seat and pull firmly
upwards to ensure that it is securely
retained.
Daytona660
Rider's Seat
▼ Align the two locating slots at the
front of the seat with the locating
tangs on the frame.
▼ Lower the rear of the seat and align
the holes for the fixings.
▼ Fit the two fixings at the rear of the
seat and tighten to 5 Nm.
WARNING
Never ride the motorcycle with the
fixings loose or removed, as the rider’s
seat will not be secure and can move.
The rider's seat is only correctly
retained and supported when the
fixings are correctly tightened.
A loose or detached seat may lead to
loss of motorcycle control which could
result in serious injury or death.
1. Rider's Seat
2. Fixings
3. Locating tang
4. Locating slot
▼ Grasp the seat and pull firmly
upwards to make sure it is securely
retained.
▼ Fit the passenger seat as follows.
To Next Page
Loading...
