Troxler NTO 2–9
2. PRODUCT SAFETY
♦ Following a burn cycle, cover the asphalt sample and basket
assembly with the sample safety cage while the sample cools.
♦ To prevent personal injury, do not touch the interior or exterior
oven surfaces (except door and control panel) during use.
♦ Depending upon environmental and other conditions, the oven
can take several hours to cool off after power is removed from
the IR element. Do not touch the interior or exterior oven
surfaces (except door and control panel) for an extended period
after use.
♦ Only qualified personnel (Troxler service representatives)
should perform service and maintenance on the oven when
disassembly is required.
♦ Always unplug the oven before performing service or
maintenance.
♦ Allow the oven to cool completely before performing service or
maintenance.
♦ Soot may build up in the exhaust connector and pipe. Troxler
recommends that the exhaust plenum box be cleaned after every
30 burn cycles, as described on page A–5.
To Next Page
Loading...
Need help?
General
