Troxler NTO series - CHAPTER 6 CALIBRATION

Troxler NTO 6–1
6. CALIBRATION
CHAPTER 6
CALIBRATION
This chapter provides information on calibrating and verifying
operating parameters for the Troxler NTO Asphalt Content Ignition
Oven. The information includes procedures for determining an
aggregate correction factor (ACF); for using the Correction Menu
to manage ACFs; and for using the Scale Menu to tare, verify, and
calibrate the integrated scale.
CONTENTS
Correcting %AC Measurements................................................... 6–2
Equipment Needed................................................................. 6–3
Preparing Correction Samples
................................................ 6–3
Calculating an ACF
................................................................ 6–7
Correction Menu........................................................................... 6–8
Select ACF ............................................................................. 6–8
Create ACF........................................................................... 6–10
Erase ACF............................................................................ 6–11
Scale Menu
................................................................................. 6–13
Tare ...................................................................................... 6–14
Auto-Tare............................................................................. 6–14
Verify ................................................................................... 6–15
Calibrate
............................................................................... 6–17