5–24
STORE FUNCTION
After burning a sample and before burning another sample, sample
data can be stored under the active project ID. (See Chapter 7 for
details on creating a project ID.) The Store selection from the MAIN
MENU enables the operator to store sample data manually.
NOTE
This function can also be accessed directly from the
default screen by pressing the 〈STORE〉 key.
After burning a sample and before burning another sample, press 〈7〉
at the MAIN MENU or press the 〈STORE〉 key if the default screen
is displayed.
If there is no sample data to be stored, the oven displays an error
message and returns to the previous display.
NOTE
The Auto-Store sample ID number is not incremented if
sample data is stored manually. When using the manual
Store function, the operator enters a sample ID number
manually. Therefore, duplicate sample ID numbers
could be stored under the active project.
For example, if the Auto-Store function is turned on for
a new project, the oven stores the sample data for the
first two burn cycles under sample IDs 1 and 2. Assume
that the Auto-Store is then turned off, and the operator
manually stores data from two more burn cycles using
sample IDs 3 and 4. If the Auto-Store function is then
turned on, the sample data for successive burn cycles
will also be stored using sample IDs 3, 4, and so on.
To prevent duplication of sample ID numbers, Troxler
recommends either using sample IDs beginning at 100
or higher when storing sample data manually or always
enabling the Auto-Store function.
To Next Page
Loading...
Need help?
General
