5–14
No Project Selected
If the operator attempts to turn the Auto-Store function on and one
or more projects have been created (see Chapter 7) but no project
has been sele
cted as active
, the oven displays:
Auto-Store requires
an active project
1. Select Project
2. Create Project
f To select an existing project, press 〈1〉. The oven displays the
screens required to select a project as described in Chapter 7.
After the project is sel
ected, the oven sets the project as active,
briefly displa
ys the confirmation shown on page 5–13, and then
returns to the Burn Setup
Menu.
f To create a n
ew project ID, press 〈2〉.
f If twenty project IDs have already been defined, the oven
displays an error message.
f If fewer than twenty projects have been defined, the oven
displays the screens required to create a project as described
in Chapter 7. When the project ID is complete, the oven sets
the project as active, briefly displa
ys
the confirmation
shown on page 5–13, and then returns to the Burn Setup
Menu.
To Next Page
Loading...
Need help?
General
