Troxler NTO 4–5
4. SETUP & OPERATION
FIRST-TIME STARTUP AND SETUP
WARNING
To prevent personal injury or equipment damage, the
operator should become familiar with the safety
warnings and information in Chapter 2 before operating
the Troxler NTO Asphalt Content Ignition Oven.
This section summarizes the initial startup and setup of the oven.
For more detailed instructions, see Chapters 5 through 7, as
referenced in this summary.
1. Ensure that the oven is installed as described in Chapter 3.
2. With the chamber door open, position the circuit
breaker/power switch, found in the lower left of the oven front
panel (see Figure 1–1), to the ON (up) position.
The oven
performs a s
elf-test, and then displays the following default
screen. The second line of the default screen shows the current
chamber temperature (25
°
C in this example). Note that the
open chamber door prevents the IR element from heating. The
chamber must be at room temperature to verify the scale as
described in step 4.
Proj PROJECT NAME
Temperature 25 C
Mass 0.0 g
11/17/2001 8:06 AM
NOTE
When the default screen is displayed, the up and down
arrow keys can be used to adjust the display contrast.
3. Press 〈MENU〉 to display the MAIN MENU.
To Next Page
Loading...
Need help?
General
