Troxler NTO 4–7
4. SETUP & OPERATION
3. Press 〈1〉 to access the Burn Setup Menu. For more
information, refer to page 5–4.
a. Press 〈1〉
to acces
s the Burn Parameter Menu. For more
information, refer to page 5–4. Set the burn mode to
Program Time or
Auto-Control, as desired (the default
setting is Auto-Control). Set the desired burn time and/or
cutoff limit. Set the calculation type to bitumen-to-sample
or bitumen-to-aggregate, as desired (the default is bitumen-
to-sample). Select the desired burn profile. Press 〈ESC〉 to
return to the Burn Setup Menu.
b. The oven features an Auto-Print function that, when turned
on, automatically prints sample data during a burn cycle. As
shipped, this function is turned on. To change the status of
the Auto-Print function, press 〈2〉. For more information,
refer to page 5–10.
c. The oven also includes an Auto-Store fu
nction that, wh
en
on, automatically stores sample data in the active project
upon completion of a burn cycle. As shipped, this function
is turned off. To turn the Auto-Store function on, press 〈3〉.
For more information, refer to page 5–12.
d. Press 〈ESC〉
to return to the MAIN M
ENU.
4. Press 〈2〉 to set up the Auto-Timer feature, if desired. The
Auto-Timer automatically powers the IR element on and off
based upon start and stop times and dates entered by the
operator. For more information, refer to page 5–15.
5. Deter
mine the aggregate c
orrection factors (ACFs), if necessary.
From the MAIN MENU, press 〈4〉 to access the Correction
Menu. Use this menu to create and store up to twenty ACFs
and to select the active ACF. For more information, refer to
Chapter 6.
To Next Page
Loading...
Need help?
General
