TSI Instruments 3080 Series

C–4 Series 3080 Electrostatic Classifiers
Command Quick Reference
The following tables provide a quick reference to all the serial
commands. Command definitions, syntax, and examples begin after
the tables. Directions for issuing commands and troubleshooting
commands are provided at the end of this section.
Read Commands
RP Read Pressure RFV Read Firmware Version
RQ Read Flow Rate RMN Read Model Name
RT Read Temperature ROT Read On Time
RUS Read User Setting RFL Read Flags
RMV Read Measured Value
Set Commands
SPDx Set Particle Diameter
SVMx Set Voltage Mode
SHVx Set High Voltage
SFMx Set Flow Mode
SQSx Set Sheath Flow Rate
SQBx Set Bypass Flow Rate
SCSAx Set Cal Sheath Parameter A
SCSBx Set Cal Sheath Parameter B
SCBAx
Set Cal Bypass Parameter A
SCBBx Set Cal Bypass Parameter B
SCI1Ax Set Cal Impactor 1 Parameter A
SCI1Bx Set Cal Impactor 1 Parameter B
SCI2Ax Set Cal Impactor 2 Parameter A
SCI2Bx Set Cal Impactor 2 Parameter B
SCI3Ax Set Cal Impactor 3 Parameter A
SCI3Bx Set Cal Impactor 3 Parameter B
SAOx Set Auxiliary Output
SFCx Set Flow Calibration Algorithm
SCTw,x,y,z Set Calibration Table
SCTCx Set Calibration Table Correct
SDMAx,y,z
Set DMA Parameter
SISx,y Set Impactor Serial Number
SOVx Set Offset Values