4: Running and Operating
Starting a Run
Running Studies
With a couple pushes on the keypad buttons, you will be running and viewing your studies. After
you’re done recording studies, you can load the study data into DMS to manipulate, analyze,
save, and create reports. (See Chapter 5 for viewing your logged data in DMS).
Starting a Run
How to run a noise study
1. If your dosimeter is turned off, press the button to power on.
2. Press and hold the button.
A 3, 2, 1 countdown will appear.
3. When running, the following will appear:
A run indicator will appear on the top-right side.
The LED indicator will flash green (unless you disabled this in DMS).
Figure 4-8: Display screen while running
Run indicator
Appears when running
Flashing green LED
Indicates running
Measurements
Use up/down arrow to
move through values.
Views are customizable
via DMS setup
To Next Page
Loading...
Need help?
General
