4: Running and Operating
Adjusting the Contrast on the Edge
Adjusting the Contrast on the Edge
Contrast
1. Ensure the meter is Off.
2. Turn the meter on by pressing the button.
3. When the splash screen appears, press and hold the and buttons until the splash
screen disappears. (See Figure 4-5 for splash screen.)
4. The Setup menu appears on the Edge. Press the up or down arrow key to select the
Contrast
icon (the arrows and enter key icons will appear to its side).
NOTE: Setup menu is used to reset the dosimeter, change the contrast, and return to the
main view.
Figure 4-7: Changing the contrast from the keypad
5. Next press the button.
6. A number will appear on your display (i.e., 50). Press the up or down arrow to increase or
decrease the contrast of the Edge.
7. Press button to accept the new contrast value.
8. To return to the measurement view screen, press the down arrow until the Checkmark
(Exit) icon is selected and press the button.
Checkmark icon
Is the selection to exit the
setup menu
Arrows and enter key
Indicate the valid keys for the
selection
To Next Page
Loading...
Need help?
General
