4: Running and Operating
Resetting the Dosimeter
Resetting the Dosimeter
The Edge can be reset through the dosimeter keypad or via DMS. This will clear out all of the
data history to ensure you have sufficient memory space on the Edge for new studies. The steps
below outline how to reset your dosimeter.
Reset
1. Ensure the meter is Off.
2. Turn the meter on by pressing the button.
3. When the splash screen appears, press and hold the and buttons until the splash
screen disappears.
Figure 4-5: Splash screen
4. The Setup menu appears on the Edge. Press the up or down arrow to select the reset
icon (the arrows and enter key icons will appear to its side).
NOTE: Setup menu is used to reset the dosimeter, change the contrast, and return to the
main view.
Figure 4-6: Resetting the Edge from the keypad
5. Press and hold the button.
6. A 3, 2, 1 countdown will appear, and then a shaded bar will appear indicating the dosimeter
is being reset.
7. To return to the measurement view screen, press the down arrow until the Checkmark
(Exit) icon is selected and press the button.
Arrows and enter key
Indicate the valid keys for the
selection
Checkmark icon
Is the selection to exit the
setup menu
To Next Page
Loading...
Need help?
General
