3: Setting up the Edge via DMS
Security Setting
Security Setting
The security setting is a type of “locking” feature (or secure run feature) that enables you to password protect
the instrument to prevent users from inadvertently terminating a study. Initially, this feature is set through the
software and turned on once in run mode by pressing run/stop key three consecutive times. (To unlock, press
run/stop key three consecutive times and then press power key.) To set this feature, please follow the steps
below.
1. Click on the Security tab from the Edge’s Instrument Configuration panel (see ❶). To enable, click on
the Enabled check box. (Ensure the specific Edge is selected and communicating to the software. See
“Communication Setup” for more information.)
2. Next, select either Not Displayed (see ❷) or Displayed (see ❸). Press Set Configuration to send
the changes to the selected instrument.
3. To set the security settings, save and send to the Edge (for more details see “Saving and Sending
Configurations”.)
Figure 3-10: Edge security setting
To Next Page
