UAV-1004234-001, AV-30-E Installation Manual 120
Rev H
On the GPS navigator, set a destination waypoint and initiate a direct-to
sequence. Note that not all navigators will output serial data until a
waypoint has been selected and navigation initiated.
13.2.7 Vibration Check
Prior to flight, a vibration check must be completed. The vibration check
helps ensure the vibration characteristics of the aircraft and installation
are suitable for use. The check procedure is performed during an engine
run-up.
1. Before applying power to the AV-30, press and hold the center rotary
knob and apply power. As the splash screen appears, check that a
minimum version of 2.1.1 is displayed.
2.
button repeatedly until the 3
rd
menu is displayed.
3.
Figure 54 – Vibe Monitor Selection
4. The Vibration Monitor will display current and peak values for the
Accelerometer and Gyroscope.
To Next Page
Loading...
