UAV-1004234-001, AV-30-E Installation Manual 39
Rev H
10.7 Wiring Diagrams
The AV-30 interfaces with several external devices and therefore wiring
will vary depending on the installation and if the unit is installed as an AI,
DG or MFD. Figure 10 shows the required connections on all AV-30.
Figure 11 shows the wiring of optional analog accessories and
measurement devices. Figure 12 shows the wiring of optional digital
accessories. Installation is likely to be an aggregate of these three
figures.
Additional details on installation of accessories can be found in Section
11 Optional Equipment Installation.
Use 22 or 24 AWG MIL-C-27500 or equivalent shielded wire unless
other is specified in the installation drawings. AC 43.13-1B should be
used for additional guidance where needed.
To Next Page
Loading...
