Unify OpenScape Desk Phone CP400 - CTI Calls; Beep on Auto-Answer; Beep on Auto-Reconnect

143
CTI calls
Beep on auto-answer
When you dial a number with a CTI application (e.g. Outlook) and auto-answer
is activated, the phone switches automatically to speakerphone mode. If auto-
answer is deactivated, the phone first rings and you have to press the loud-
speaker key or lift the handset in order to set up the call. This setting also defines
whether or not incoming calls are automatically accepted. If the function is ac-
tive, an alert beep sounds when a call is automatically accepted.
Information on the operation of the configured CTI application can be found in
the corresponding operating instructions.
z You can also configure this setting via the web interface  page 172.
@ Press the key shown if appropriate.
Open using the Softkey.
Open using the Softkey.
if nec. j Enter and confirm the User password.
Open using the Softkey.
Open using the Softkey.
Open using the Softkey.
Enable or disable using the Softkey.
and
€ Switch to AutoAnswer beep.
Enable or disable using the Softkey.
Save the setting with the Softkey.
Beep on auto-reconnect
You can reconnect a held call both via the CTI application and via the phone. A
beep sounds when you toggle between an active call and a held call when the
function is active.
z You can also configure this setting via the web interface  page 172.
ñ
The option was programmed by your administrator.
Settings
_
$
User settings
-
_
$
Configuration
-
_
$
Incoming calls
-
_
CTI calls
-
_
AutoAnswer
¢_
AutoAnswer beep
¢_
Q
_