Unify OpenScape Desk Phone CP400 - Dialing with the Selected Dialing Key; Dialing from Conversations

63
Z Confirm that the phone number is complete or wait until the autodial delay ex-
pires (see
 page 66).
or
The required conversation is shown in the list. Confirm with the Softkey. The
connection is set up.
Entering the phone number first
First enter the number. The loudspeaker or headset key illuminates when you
enter the first digit.
j Enter the phone number. If necessary, correct input using the navigation keys.
Z Confirm that the phone number is complete or wait until the autodial delay ex-
pires (see
 page 66).
or
The required conversation is shown in the list. Confirm with the Softkey. The
connection is set up.
Dialing with the selected dialing key
You can program frequently used phone numbers on programmable keys
 page 86. If you press a selected dialing key, the associated contact or phone
number is displayed and the connection is set up.
Prerequisite: A Function key for selected dialing is programmed
 page 86.
Press the Function key for a saved number. The connection is set up.
Dialing from conversations
Depending on the configuration, the conversation list can contain data from the
following directories:
• Caller list
• Subscriber data from Circuit
• Subscriber data from Exchange
• Subscriber data from the LDAP directory
If you cannot find redials or received or dialed calls in the list, check if the call
journal is activated.
The conversations list is displayed on the screen. If the contact you want is not
visible, then select with
μ€ or search by entering the phone number or name.
©
123456789
O
Georg Simon Ohm O
_
©
123456789
O
Georg Simon Ohm O
_
Party
_