Unify OpenScape Desk Phone CP400 - Call Forwarding and Recording; Configuring Call Forwarding

77
Ending a call
Press the Softkey shown.
or
Ê Press the key shown. The key LED goes out.
or
É Press the key shown. The key LED goes out.
or
] Replace the handset.
After the call has ended (either by you or the remote party), end of call notifica-
tion with duration of the call will be shown on the phone screen:
Configuring call forwarding
z You can also configure this setting via the web interface  page 172.
@ Press the key shown if appropriate.
Open using the Softkey.
Open using the Softkey.
if nec.
j Enter and confirm the User password.
Open using the Softkey.
Open using the Softkey.
Open using the Softkey.
Disconnect
à
_
You can also enter the call forwarding settings via the "Presence" key
(
 page 138).
This is how you set local call forwarding on an OpenScape 4000.
Conversations
Voicemail
Settings
Call with Tom ended. Duration 00:10
Settings
_
$
User settings
-
_
$
Configuration
-
_
$
Incoming calls
-
_
$
Forwarding
-
_