73
Connecting parties
You can connect the first party with the party you consulted, clearing down your
connection to both parties in the process.
Prerequisite: You are making a consultation call
page 69 and you are in the
call menu of an active call.
Press the Softkey. The other two parties are now connected to one another. You
can now hang up.
or
Connecting by hanging up
Prerequisite: Call joining must also be allowed page 149.
] or É Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. The other two parties are now connected to one another.
Placing a call on hold
You can use this function to place an ongoing call on hold, for instance to prevent
the other party overhearing a conversation with a colleague in the same room.
The held party hears music on hold.
Press the Softkey. The call is now on hold.
or
Press the Function key. The key illuminates. (The "Hold" key has to be config-
ured
page 86).
It is documented in the main menu and in the conversations menu that a call is
on hold. The call display lights up orange at the same time.
Retrieving a held call:
Press the Softkey. You resume the call.
or
Press the illuminated "Hold" Function key. (The "Hold" key has to be pro-
grammed
page 86.)
Disconnecting a held call:
Press the Softkey to disconnect the held call.
Call waiting (second call)
Complete transfer
D
_
Hold
I
_
Hold
_
If you do not retrieve the held call after a defined time interval, a reminder
beep sounds three times. Only the two functions "Retrieve held call" and
"End" are then shown on the display. The call display flashes orange and
the phone rings. The relevant settings can be fond on
page 145 and
page 146.
Reconnect
C
_
Hold
¤
End
P
_
To Next Page
Loading...
