Unify OpenScape Desk Phone CP400 - Permitting Call Deflection

150
Permitting call deflection
z You can also configure this setting via the web interface  page 172.
@ Press the key shown if appropriate.
Open using the Softkey.
Open using the Softkey.
if nec. j Enter and confirm the User password.
Open using the Softkey.
Open using the Softkey.
Open using the Softkey.
Activate with the Softkey.
Open the setting by selecting the Softkey.
j Enter the phone number to which the subscriber is to be deflected and confirm
(see
 page 23).
or
Deflecting to a DSS number
A call can be deflected to a direct station selection (DSS) subscriber using the
DSS key, if the key is configured and the deflect function is activated by your ad-
ministrator
 page 95.
Settings
_
$
User settings
-
_
$
Configuration
-
_
$
Incoming calls
-
_
Deflect
-
_
Allow deflection
¢_
Default destination
K
_
Entering a destination phone number is not mandatory when call deflec-
tion is active. To forward a call, you will be prompted in the case of the un-
saved destination phone number to enter a destination number or select a
corresponding subscriber from the conversations list.
Deflect to DSS
¢_
ñ
Information only, as set by the administrator: On or off.