Unify OpenScape Desk Phone CP400 - Using Autodial Delay

66
Using autodial delay
A number is automatically dialed after a set delay starting from the entry of the
number's last digit. The autodial delay can be used:
• when dialing in idle mode
• when deflecting an incoming call
• during a consultation
• when transferring an answered call
The delay can be reduced by performing one of the following activities:
• Press the
Z key. This always works.
• Lift the handset. This only works if the phone number was entered when the
phone was idle or if it was entered for a consultation call when the handset was
off hook.
If an emergency number is preset by your administrator, the autodial delay
for this phone number is reduced to one second.