EasyManuals Logo

Utax CDC 1730 User Manual

Utax CDC 1730
436 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #197 background imageLoading...
Page #197 background image
Sending Functions
5-29
5
Job Finish Notice
Sends a notice by e-mail when a job is completed.
Use the procedure below to specify the Job Finish Notice settings.
1 Press the Send key.
2 Place the originals on the platen.
3 Press [Advanced Setup] and then [Job Finish
Notice].
4 To select the destination from the address book,
press [Address Book] on the left of the screen and
then press [Address Book] in the next screen.
Select the destination to be notified, then press
[OK].
You can view information on the notification
destination by pressing [Detail].
5 Specify the destination to send the finish notice,
and press [OK].
NOTE: For the procedure to select the destination
from the Address Book, refer Specifying Destination on
page 3-30.
6 To directly enter the address, press [Address Entry]
and then [E-mail Address].
7 Enter the E-mail address, and press [OK].
8 Press [OK].
9 Specify the destination, and press the Start key to
start sending.
When the sending is completed, the finish notice is
sent to the specified E-mail address.
Job Finish Notice
Destination Detail
Detail Address Book
Address
Entry
Address Book
Off
Place original.
Ready to send.
Destination
Cancel OKAdd Shortcut
Status
08/08/2009 10:10
Job Finish Notice
E-mail
Address
Address
Entry
Address Book
Off
Place original.
Ready to send.
Destination
Cancel OKAdd Shortcut
Status
08/08/2009 10:10

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Utax CDC 1730 and is the answer not in the manual?

Utax CDC 1730 Specifications

General IconGeneral
BrandUtax
ModelCDC 1730
CategoryAll in One Printer
LanguageEnglish

Related product manuals