Preparation before Use
2-10
Sleep and Auto Sleep
Sleep
To enter Sleep, press the Power key. Touch panel and
all indicators on the operation panel will go out to save
a maximum amount of power except the Main Power
indicator. This status is referred to as Sleep.
If print data is received during Sleep, the print job is
performed while the touch panel remains unlit.
When using the optional fax, received fax data is printed
out while the operation panel also remains unlit.
To resume, press the Power key. The 25/25 ppm or 30/
30 ppm model will be ready to use within 30 seconds,
the 40/40 ppm or 50/40 ppm model will be ready within
45 seconds, or the 55/50 ppm model will be ready within
57.5 seconds.
Note that ambient environmental conditions, such as
ventilation, may cause the machine to respond more
slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time in the Low Power Mode.
The default preset time is 30 minutes for 25/25 ppm and 30/30 ppm models, 45 minutes for 40/40 ppm model,
or 60 minutes for 50/40 ppm model and 55/50 ppm models.
To Next Page
Loading...
Need help?
General
