Default Setting (System Menu)
8-58
Sleep Timer
Set the amount of time to wait before Auto Sleep. Options are between 1 and 240 minutes (every one minute).
NOTE: If you select [Off] for Auto Sleep, the time display does not appear.
Use the procedure below to set the Auto Sleep time.
1 Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Change] of Sleep Timer.
3 Press [+] and [–] or the numeric keys to enter the time until Auto Sleep is turned on.
4 Press [OK].
Auto Error Clear
If an error occurs during printing, the print job stops to wait for the next step to be taken by the user. In the Auto
Error Clear mode, automatically clear the error after a set amount of time elapses.
The following errors are automatically cleared.
Print overrun
Memory is full
Auto Error Clear ON/OFF
Select whether to use Auto Error Clear or not.
Use the procedure below to specify the auto error clear setting.
1 Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Change] of Auto Error Clear.
3 Press [Off] or [On].
4 Press [OK].
To Next Page
Loading...
Need help?
General
