Appendix-7
Character Entry Method
To enter characters for a name, use the on-display keyboard in the touch panel following the steps as explained
below.
NOTE: QWERTY, QWERTZ and AZERTY are available as keyboard layouts the same as a PC keyboard.
Press the System Menu key, [Common Settings] and then [Change] of Keyboard Layout to choose desired
layout. QWERTY layout is used here as an example. You may use another layout following the same steps.
Entry Screens
Lower-case Letter Entry Screen
Status
10/10/2008 10:10
Use the keyboard to enter.
Backspace
Upper-case No./Symbol Space
Cancel OK
Input: characters
Limit: characters
0
128
Lower-case
1 2 3 4 5 6 7 8 9 0 ! = ^
q w e r t y u i o p [ ]
a s d f g h j k l ; :
z x c v b n m , . /
\
No. Display/Key Description
1 Display Displays entered characters.
2 Limit Display Displays maximum number of characters.
3 Cursor Key Press to move the cursor on the display.
4 [Backspace] Press to delete a character to the left of the
cursor.
5 Keyboard Press a character to enter.
6 [Upper-case] Press to use upper-case letters.
7 [Lower-case] Press to use lower-case letters,
8 [No./Symbol] Press to enter numbers and symbols.
9 [Space] Press to insert a space.
To Next Page
Loading...
Need help?
General
