Default Setting (System Menu)
8-79
8
4 Press [OK].
5 After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-72.
IPSec Setting
Sets up IPSec. The default setting is Off. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network, and then [Change] of IPSec.
NOTE: If user login administration is disabled, the user authentication screen appears. Enter your login user
name and password and then press [Login]. For this, you need to login with administrator privileges. Refer to
Adding a User on page 11-5 for the default login user name and password.
3 Press [On].
4 Press [OK].
5 After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-72.
LAN Interface Setup
Specify the settings for the LAN interface to be used. The default setting is Auto. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Change] of LAN Interface.
3 Select [Auto], [10BASE-T Half], [10BASE-T Full], [100BASE-TX Half] or [100BASE-TX Full] as the LAN
interface.
4 Press [OK].
5 After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-72.
To Next Page
Loading...
Need help?
General
