Default Setting (System Menu)
8-82
Limitations:
- Scanning speed will be limited to the speed of scanning 600 dpi image. (Printing speed will not
be limited.)
- FAX transmission will be limited to the memory transmission.
Note:
- The Printed Document Guard Kit should not fully prevents a leak of information. We do not
guarantee any loss incurred while using this feature or when malfunction occurred with this
feature.
- The guard pattern printed on the colored paper or paper that is decorated with special design
may not be detected.
- We do not guarantee the integrity of the detection. If the malfunction occurs, contact your service
representative.
Use the procedure below to specify the Document Guard setting.
1 Press the System Menu key.
2 Press [System] and then [Change] of Document Guard.
NOTE: If user login administration is disabled, the user authentication screen appears. Enter your login user
name and password and then press [Login]. For this, you need to login with administrator privileges. Refer to
Adding a User on page 11-5 for the default login user name and password.
3 Press [On].
4 Press [OK].
To Next Page
Loading...
