Utax CDC 1730 - Page 51

Preparation before Use
2-15
2
8 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-72.
Auto-IP Settings
Select whether or not to use Auto-IP. The default setting is On.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Change] of TCP/IP.
4 Press [On] and then press [OK].
5 Press [Change] of IPv4.
6 Press [Auto-IP].
7 Press [On] or [Off] of Auto-IP and then press [OK].
8 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-72.
AppleTalk Setup
Select the Apple Talk network connection. The default setting is On.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then
[Change] of AppleTalk.
3 Press [On] or [Off].
4 Press [OK].
5 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-72.