General Information
February 2011 1-8 P/N 06-237041-001
1-7.1.4 REMOTE ENCLOSURE
A smaller enclosure has been designed with common mounting features to house either the Remote
Display Control Module (RDCM) or LED Annunciator Module optional devices (Figure 1-6). A Lexan
window aligns with the display, LEDs, alphanumeric keypad and switches such that these features
can be viewed but not touched with the door in the closed position. The key-locked door hinges on
the left and opens to a full range of 180 degrees.
The Remote Enclosure allows a minimum of 2 in. (50 mm) of wiring space between the wall and
wiring terminals. Two conduit knockouts are provided at the top of the enclosure to accommodate
either 0.5 in. or 0.75 in. standard electrical conduit fittings. An additional conduit knockout of the
same size is provided in the center of each side.
The Remote Enclosure, as with all FenwalNET 8000-ML enclosures, can be surface or semi-flush
mounted. A trim ring for the Remote Enclosure (P/N 74-800300-004) fits over the enclosure.
Refer to Installing the Remote Enclosure (in Chapter 2) for mounting instructions.
Figure 1-6. Illustration of Remote Enclosure (shown with Remote Display Control Module)
1-7.1.5 LARGE CAPACITY BATTERY CABINET
A stand-alone Large Capacity Battery Cabinet (P/N 74-600000-514) is available if required battery
capacity is greater than can fit into the Main or Expansion Enclosure(s). The NEMA-1 Large Capacity
Battery Cabinet is constructed of the same cold-rolled steel as the other available FenwalNET 8000-
ML enclosures and is painted red. The Large Capacity Battery Cabinet door is hinged on the left and
includes the same lock and key used with the FenwalNET 8000-ML enclosures. Three conduit
knockouts are provided at the top to accommodate either 0.5 in. or 0.75 in. standard electrical
conduit fittings.
7.50 in.
(190.50 mm)
12.75 in.
(323.85 mm)
To Next Page
Loading...
Need help?
General