UVITEC – Cambridge
205/225
Image
3
+
=
The increment time is 10s.
Image C has the exposure time of the previous image (30s) plus the increment time (10s).
Image 3 is the result of the addition of image 2 plus Image C.
n
Image
…
The number of images of the serie is defined by the Number of images parameter.
Note: the series could stop automatically before the Number of images parameter is reached if the
Stop when the saturation is reached is selected. If this option is on, the serial process is
stopped
automatically when the saturation pixel is reached on the obtained accumulated image.
The Accumulation mode
In the accumulation mode, you define a same exposure time for each image of the series. Then from
the second image acquired, each new image is added to the previous one.
Example:
Image
1
20second is the Time per image
Image
2
+
=
Image B has the exposure time of the previous image (20s)
Image 2 is the result of the addition of image 1 plus Image B.
Image
3
+
=
Image C has the exposure time of the previous image (20s).
Image 3 is the result of the addition of image 2 plus Image C.
n
Image
…
The number of images of the serie is defined by the Number of images parameter.
Note: the series could stop automatically before the Number of images parameter is reached if the
Stop when the saturation is reached is selected. If this option is on, the serial process is
stopped
automatically when the saturation pixel is reached on the obtained accumulated image.
40s -Image B
Image 2
Image 3
20s
20s -Image B
20s
20s -Image B
Image 2
Image 3
Image 2
To Next Page