47
English
LUNA 2.0 AI USER MANUAL
The Ascent/Descent symbol is used to indicate decompression and level stops during scuba dives.
• As long as there is no-stop time left, the symbol will not be shown.
• If the diver is at a depth deeper than the next level or deco stop, the wave symbol with the upwards arrow will
be shown.
• If the diver is at the correct depth for the level or deco stop, the wave symbol with both upwards and
downwards arrows will be shown.
• If the diver is at a depth shallower than the next level or deco stop, the wave symbol with the downwards
arrow will be shown.
3 .5 Diving in GAUGE mode
When the LUNA 2.0 AI is set to GAUGE mode, it will only monitor depth, time, temperature, tank pressure and
heart rate, and will not carry out any decompression calculations. Due to this there are fewer screens with dive-
related information to scroll through than in SCUBA mode. You can only switch to GAUGE mode if the computer
is completely desaturated. All audible and visual warnings and alarms, other than the low battery, max depth and
max dive time are disabled.
WARNING
Dives in GAUGE mode are performed at your own risk. After a dive in GAUGE mode, you must wait at least 48 hours before diving
using a decompression computer.
When on the surface after a dive with GAUGE mode, the LUNA 2.0 AI will show neither the remaining desaturation
time nor the CNS O
2
% value. It will, however, display a surface interval of up to 24 hours and a 48-hour no-y time.
The no-y time is also the time during which you cannot change the dive mode.
In GAUGE mode the following screens illustrate the different dive related information in the matrix area of the display
which can be scrolled through using the two push-buttons.
Date and current time Heart rate and skin temperature
To Next Page
Loading...
Need help?
General
