75
English
LUNA 2.0 AI USER MANUAL
adjustable between 21% and 50% for Gas 1.
.21% and 100% for Gas 2 and Gas 3.
Operating temperature:
-10C° to +50C° / 14F° to 122F°.
Power supply:
Lithium type CR2450 battery.
Operation time with fresh battery:
Up to 2 years. Actual battery operation time depends primarily on the operational temperature and backlight
settings, but also on many other factors.
Bluetooth
®
transceiver:
Operating frequency 2402-2478 MHz, max power < 3 dBm, connection range up to approx. 2m.
6 .2 Maintenance
The dive computer’s depth accuracy should be veried every 2 years by an authorized SCUBAPRO dealer. The last
service date can be checked from the main menu: Settings -> User -> Service.
The tank pressure gauge and the parts of this product used to measure tank pressure should be serviced by an
authorized SCUBAPRO dealer every other year, or after 200 dives (whichever comes rst).
Aside from that, your LUNA 2.0 AI is virtually maintenance-free. All you need to do is rinse it carefully with fresh
water after each dive and replace the battery when needed.
To avoid possible problems with your dive computer, the following recommendations will help assure years of
trouble-free service:
• Avoid dropping or jarring your dive computer.
• Do not expose your dive computer to intense, direct sunlight.
• Do not store your dive computer in a sealed container; always ensure free ventilation.
• If there are problems with the water contacts, use soapy water to clean your dive computer and dry it
thoroughly.
• Do not use silicone grease on the water contacts!
• Do not clean your dive computer with liquids containing solvents.
• Check the battery capacity before each dive.
• If the battery warning appears, have the battery replaced by an authorized SCUBAPRO dealer.
• If any error message appears on the display, take your dive computer back to an authorized SCUBAPRO dealer.
6 .3 Updating the rmware of your LUNA 2.0 AI
In order to update the operating software on your LUNA 2.0 AI dive computer, you need to download the SCUBAPRO
LogTRAK mobile application.
To perform a software update, follow the below steps:
1. Turn on Bluetooth on you dive computer
2. Make sure you have Bluetooth enabled on your mobile device
3. Open SCUBAPRO LogTRAK 2.0 mobile application
4. Navigate to Equipment in LogTRAK 2.0
a) First time: Press Add new and select your dive computer. Enter the pin shown on your dive computer’s
screen.
b) Already added dive computer: Select your dive computer from the list.
To Next Page
Loading...
Need help?
General
