71
English
LUNA 2.0 AI USER MANUAL
The silicone arm strap can be removed by unscrewing the 2mm hex head screws at the corners of the arm strap
xture, like in the below illustration.
4 .3 Wireless high pressure transmitter
The LUNA 2.0 AI supports wireless tank pressure using Smart series transmitters. With the PMG function enabled
you can use up to 3 transmitters with your LUNA 2.0 AI.
Transmitters can be purchased separately from your authorized SCUBAPRO dealer.
F
NOTE: There are 4 generations of Smart transmitters: Smart, Smart+, Smart+ LED and Smart+ PRO.
4 .4 SCUBAPRO Digital Heart Rate Monitor
The new SCUBAPRO Digital Heart Rate Monitor is a wireless heart rate and skin temperature transmitter that forms
an integral part of the functionality of a variety of compatible SCUBAPRO dive computers. The heart rate monitor
allows you to measure and display heart rate and skin temperature in real time during diving.
The heart rate monitor must be paired with your LUNA 2.0 AI before the rst use. After this initial pairing the heart
rate monitor will be on standby and ready to send data.
To establish the connection follow the steps below:
• Enable the heart rate setting in your LUNA 2.0 AI by going to the menu Settings->User->Workload and
selecting HRT RATE. In this menu you can also set your base and max HR values.
• Remove the heart rate module from the elastic strap by unclipping it from the metal snap fastener.
• Go to menu Settings->User->D-HR belt in your LUNA 2.0 AI. Make sure your LUNA 2.0 AI is close to the
digital heart rate monitor when activating the pairing mode.
• Place your thumbs on the two metal snap fasteners on the back of the transmitter module and check the
To Next Page
Loading...
Need help?
General
