36
LUNA 2.0 AI USER MANUAL
F
NOTE: The transmitter must have been unpressurized for at least 40 seconds prior to performing the pairing
operation; otherwise, it will not transmit the pairing sequence. A transmitter can only be paired to one tank
designation. If you pair the same transmitter to a second tank designation, the rst one will be erased. However,
you can pair more than one LUNA 2.0 AI (or other compatible SCUBAPRO dive computers) to the same
transmitter.
F
NOTE: The Smart transmitter has a range of approximately 1.5m/5ft.
• To maximize the life of the battery, the transmitter operates at a low update rate when there is no pressure
change for more than 40 seconds. The transmitter also turns itself off when the pressure is 14bar/200psi or
less.
• If a transmitter battery is weak, the LUNA 2.0 AI will alert you with a screen message displaying the tank
assigned to that transmitter as shown on the screen below (T1 batt).
See chapter Replacing the battery in the high pressure transmitter for information on how to replace the
transmitter’s battery.
2 .3 .4 Nitrox reset time
If you are usually diving with air and want to return to this setting after the occasional nitrox dive, you can preset a
default time when your LUNA 2.0 AI will set back to air.
By entering the O
2
reset submenu you can set the reset time from 1 hour up to 48 hours. The nitrox reset time is
disabled when -- h is shown on the display.
To Next Page
Loading...
Need help?
General
