8
LUNA 2.0 AI USER MANUAL
1 . INTRODUCTION TO THE LUNA 2.0 AI DIVE COMPUTER
There are two versions of the LUNA 2.0, and in the following chapters this user manual describes the LUNA 2.0 AI,
the version with air integration and heart rate module.
The LUNA 2.0 AI is a sleekly designed and ergonomically shaped dive computer with wireless air integration and
heart rate and skin temperature monitoring, selectable ZH-L16 ADT MB PMG and ZH-L16C+GF PMG algorithms,
user updateable rmware, user replaceable battery, high contrast black and white matrix-segment display, and
Bluetooth low energy interface.
1 .1 Switching on and off the LUNA 2.0 AI
IMPORTANT
The LUNA 2.0 AI is delivered in deep sleep mode where the display is off. You must activate it with a long-press of both left and
right buttons before the rst dive.
After being woken up from deep sleep the LUNA 2.0 AI can be switched on manually, by simultaneously pushing
and holding the left and right buttons.
When switched on the following screen will be shown:
After switching on, the display shows the following information:
• dive computer name
• date
• day of week
• battery status
• temperature
• time of day
• selected dive mode (diver icon)
This is referred to as the surface screen.
In the surface screen, if there is remaining saturation from the last dive or from a change of altitude, the LUNA 2.0
AI may indicate the “Do not y” icon, “Do not dive” icon or “Altitude” icon or a combination of the icons depending
on the situation.
In the above screen the bar in the right side of the display represents the tissue saturation:
• 6 bars = full saturation
• No bar = desaturation complete
F
NOTE: When the LUNA 2.0 AI is in a state of rest, no information is displayed but the atmospheric pressure
continues to be monitored.
To Next Page
Loading...
Need help?
General
