EasyManuals Logo

Uwatec LUNA 2.0 AI User Manual

Uwatec LUNA 2.0 AI
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
78
LUNA 2.0 AI USER MANUAL
WARNING
If the screw connection is forced, the screws can break off. Damage to the dive computer caused by an improperly replaced
battery is not covered by the warranty.
F
NOTE: For best results use the battery set available at your authorized SCUBAPRO dealer.
6 .5 Replacing the battery in the Smart+ PRO high pressure transmitter
a
b
c
d
e
f
The Smart+ Pro transmitter uses Lithium CR2 type battery.
We recommend having the battery of the transmitter replaced by an authorized SCUBAPRO dealer. The change
must be made with particular care in order to prevent water from seeping in. The warranty does not cover damages
due to improper replacement of the battery.
Remove the transmitter from the HP port of the first stage regulator.
Dry the transmitter with a soft towel.
Remove the lock ring with a pair of ring pliers. (f)
Slide the outer sleeve downwards. (e)
Remove the transmitter lower and upper O-Ring. (b & d)
Slide the lid to the side. (c)
Remove the battery. (a)
Insert new battery and new O-rings.
Wait 30 seconds.
Carefully slide back the lid onto the housing. Make sure that the lid is slid exactly up to the stop on the core
part. Check the fit of the two O-rings. Then slide back the outer sleeve towards the stop of the lid.
Install the lock ring. Carefully check the fit of the lock ring. It must be located perfectly inside the groove.
F
NOTE: For best results use the transmitter battery set available at your authorized SCUBAPRO dealer.
6 .6 Replacing the battery in the Digital Heart Rate Monitor
The digital heart rate monitor is powered by a user-replaceable CR2032 type lithium battery. However, in order to
avoid leakage by incorrect closure of the battery compartment cover, we recommend having the battery replaced
by an authorized SCUBAPRO dealer.
The following parts of the heart rate monitor are shown in the drawing below:
1. screws for battery compartment cover
2. battery compartment cover
3. O-ring
4. CR2032 battery
5. heart rate monitor module

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uwatec LUNA 2.0 AI and is the answer not in the manual?

Uwatec LUNA 2.0 AI Specifications

General IconGeneral
BrandUwatec
ModelLUNA 2.0 AI
CategoryDiving Instrument
LanguageEnglish

Related product manuals