4
vacon • 33 User Interfaces
Changing control places
Change of control place from
Remote to Local (keypad).
1. Anywhere in the menu structure, push the FUNCT button.
2. Using the arrow buttons, select Local/Remote and confirm with the OK button.
3. On the next display, select Local or Remote and again confirm with the OK button.
4. The display will return to the same location as it was when the
FUNCT button was pushed.
However, if the Remote control place was changed to Local (Keypad) you will be prompted
for keypad reference.
Figure 12. Changing control places
Accessing the control page
The
Control page is meant for easy operation and monitoring of the most essential values.
1. Anywhere in the menu structure, push the
FUNCT button.
2. Push the
Arrow up or the Arrow down button to select Control page and confirm with the
OK button.
3. The control page appears
If keypad control place and keypad reference are selected to be used you can set the
Key-
pad Reference
after having pressed the OK button. If other control places or reference val-
ues are used the display will show Frequency reference which is not editable.
Figure 13. Accessing Control page
To Next Page
Loading...
