3. Face the sensor product label South, if possible, and mount the sensor to the flange by
twisting.
4. Tighten the screws.
5. Mount the assembly and tighten the fixing screw.
6.4.3 Mounting Wind Set on Mast
6‑mm Allen key
You can install the wind set on top of a 60‑mm (2.36‑in) mast.
1. Place the cross arm on the mast.
2. Tighten the bolts. Tightening torque 5 Nm.
3. Align the wind set.
AWS310/AWS310-SITE Installation Manual M211584EN-F
68
To Next Page
Loading...
