MM101 – D-4E HOT MELT UNIT 11
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 melton@melton.es www.valcomelton.com
Warning! Do not use a water extinguisher to extinguish the fire!
OTHERWISE, PERSONAL INJURY OR EQUIPMENT
DAMAGE COULD OCCUR.
If the hot-melt adhesive ignites, promptly perform the following steps:
1. Sound a fire alarm.
2. Evacuate the immediate area.
3. Turn off all local electrical equipment at the source.
4. Fight the fire in one of the following ways:
• Smother the fire with a fire blanket.
• Aim a CO2 fire extinguisher at the base of the flames
• Aim a dry-powder fire extinguisher at the base of the
flames
If Adhesive fumes are inhaled, immediately follow these steps:
1. Take the victim away from the immediate work area.
2. Provide victim with fresh air.
3. Call a qualified medical authority.
What to Do if
Inhalation of
Adhesive
Fumes Occurs
To Next Page
Loading...
