MM101 – D-4E HOT MELT UNIT 71
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 melton@melton.es www.valcomelton.com
Warning! Do not overfill the tank. The adhesive could leak out and
damage equipment and cause extensive burns to persons.
DAMAGE TO EQUIPMENT AND DEATH OR PERSONAL
INJURY COULD OCCUR.
Warning! Always wear insulated gloves, clothing, and proper eye
protection when working around hot melt equipment. A
protective screen around the face is also recommended.
OTHERWISE, DEATH OR PERSONAL INJURY COULD
OCCUR.
Warning! Always use the same adhesive type in the unit. If it is
necessary to change the adhesive type, completely flush the
system by following all instructions in the Maintenance
Section (or call ValcoMelton for full instructions).
OTHERWISE, DAMAGE TO EQUIPMENT COULD OCCUR.
To fill the tank, do the following:
Warning! Use caution when opening the tank lid and filling the tank.
Wear gloves and eye protection. Burns and splashing of
molten adhesive may occur. DEATH OR PERSONAL
INJURY COULD OCCUR FROM BURNS.
1. Open the tank lid.
2. Fill the tank with the proper type of hot melt. Use a small scoop and
fill the tank slowly to avoid splashing hot melt adhesive or overfilling
the tank.
3.
Cierre la tapa del tanque lentamente y con cuidado para evitar
salpicaduras de adhesivo caliente.
The tank should be kept 3/4 full at all
times to avoid build-up of char on the
sides of the tank.
The capacity of the D4-E tank is 9 lbs. (4
kg)
The tank lid should be kept closed to
minimize heat loss, reduce vapors, and
prevent debris from contaminating the
tank and the adhesive.
Filling
the tank
To Next Page
Loading...
