MM101 – D-4E HOT MELT UNIT 13
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 melton@melton.es www.valcomelton.com
SECTION 4 - INSTALLATION
The D4-E hot melt unit is assembled at the factory. However, the power
and the glue hoses must be connected by the customer. This section
contains instructions for making the necessary connections.
While choosing a location for the unit, keep in mind that:
• Service personnel will need access to the left and right sides of the
unit for electrical service, and the back of the unit for changing the
glue hoses and filter.
• The operator needs easy access to the front operator panel.
• If the unit will not be moved from one location to another, it should
be screwed or bolted to a suitable stable, flat, level surface.
• The unit should have clearance around the outside of the case to
allow air to circulate freely around it.
• The unit should have clearance above the top of the unit so it may
be filled easily without obstruction to the operator.
• The location should be near the glue station so that the glue hoses
can be routed to the applicators in as straight a line as possible.
• The location for the unit should be clean. Dirt in the glue tank
causes clogging of the applicator nozzles.
• The unit should be protected from high and low ambient
temperatures, as well as from rapid changes in ambient
temperature.
• The unit must be protected from condensate and water. The unit
must be protected from strong vibrations.
• The tank lid must be able to open fully back so there is no danger
of it falling onto operator’s hands while filling.
Location
To Next Page
Loading...