MM101 – D-4E HOT MELT UNIT 64
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 melton@melton.es www.valcomelton.com
SECTION 6 - OPERATION
Warning! It is recommended that Section 5 - Programming is read,
understood, and followed before attempting to read this
Section and operate the D4-E unit. OTHERWISE, DAMAGE
TO EQUIPMENT AND PERSONAL INJURY COULD
OCCUR.
To start the unit, do the following:
1. Toggle the Power On/Off Switch to the “On” position to power up
the system.
Power On/Off Switch
The Standby LED will illuminate green
when the power to the unit is on. If the
Standby LED illuminates orange, the
unit is in Standby Mode. Press the
Standby Button to turn the unit on.
Standby LED
Green = unit on
Orange = unit in Standby Mode
Standby Button
Operation
Start the unit
To Next Page
Loading...
