MM101 – D-4E HOT MELT UNIT 7
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 melton@melton.es www.valcomelton.com
SECTION 1 – INTRODUCTION
ValcoMelton, a division of Valco Cincinnati, Inc., has prepared this manual
as an aid for installing, operating, and servicing the D4-E hot melt unit. It
also contains a list of part numbers for replacement parts. If you need more
information, contact your ValcoMelton representative.
Description
The D4-E hot melt unit is a low-volume system designed to melt and pump
thermoplastic adhesives. The D4-E unit features a precision electronic
temperature control, a digital multi-zone temperature display, an electric
motor-driven gear pump, and an adjustable pressure control.
Features and capabilities include:
o Precision electronic temperature control
o Capacity of up to (2) hoses and guns
o Positive displacement electric motor-driven gear pump
o Adjustable pressure control
o Integrated over-temperature protection
o User selectable inputs and output
To Next Page
Loading...