1132
Model Code Page
80. Cab and shields
8. 11. 1990
6000--8750 811 2
B. Fitting c ab
1.Liftthecabontothetractorframeandguidealldetached
parts into places. Make sure that the auxiliary hydraulic valve
levers fit through their hole.
2. Tighten the cab attaching bolts.
Connect the following parts in front of the cab on the LH
side:
--- stop control cable to the injection pump
--- clutch adjusting rod to the clutch lever (fit the adjuster stop
on the rod according to the measurement)
Connect the following parts to the cab front wall:
--- socket and the accelerator pedal cable
--- steering valve bracket
--- cab earth lead
--- connect the cable to the starter motor
--- connect the windscreen washer hose and cable connector
--- connect the cab heater hoses and fill the cooling system
Connect on the RH side of the tractor:
---shifterrodstothegearleverlowerends
--- shifter cables to the selector levers and gear lever lower
ends.
--- ground speed PTO control cable wire (optional)
--- solenoid valve leads to the control valve of the hydraulic lift
Connect at the rear of the tractor on the RH side:
--- hydraulic lift sensor connectors
--- PTO control cable lower end
--- pick---up hitch release co ntro l lower end
--- lifting link gear control rod lower end
Connect at the rear of the tractor on the LH side:
--- connector for the solenoid valve leads
--- sensor leads to the servo valve block
Fitattherearofthetractor:
--- brake cylinders (or brake pipe joints)
--- parking brake cable
3. Connect the battery cables. Test run the tractor and ensure
that the electrical system and the control levers function
properly. Bleed, if necessary, the brake system and adjust the
brakes.
4. Ensure that the accelerator pedal and stop control cables
have been fitted correctly. Fit the engine hood plates.
Note! If you detached the cab in the way which needs lesslift-
ing space (see the note in the beginning of instruction A),
carry out the foll owing steps:
--- attach the auxiliary hydraulic valve set bracket to the gear-
box (work through the access hole).
--- connect the quick---action couplings to the bracket at the
rear of the tractor.
--- fit the access hole cover and the rear wheels
To Next Page
Loading...
Need help?
General
