S T [ --- n ]
This question above shows five measuring values from the special tracking log from beginning of measurement
no ---n and backwards. In this log parameter ---n can vary between 1---2000.
Control of special tracking log
One measuring point is switched on to the special tracking mode with ST command.
ST ZZ
In the command above, ZZ is a two---letter name of the measuring point in question.
The STOP command below stops the gathering of data into the special tracking log.
ST STOP
Zeroing of this log is with the CLEAR command below.
ST CLEAR
Note! In the special tracking is gathered 2000 different measuring values from certain sensor in frequency of
normal standard log. The measuring frequency has been set in the factory. Default value is 10 seconds.
G. Control of automatic alarm messages
CALL ID OFF
CALL ID ON
ID=tractor serial number
OFF=automatic alarm messages are not sent.
ON=automatic alarm messages are sent
When the above shown command has been sent, CareTel sends a confirm (ACK CALL=positive confirm, NACK
CALL=negative confirm. The confirms show also the tractor serial number and running hours.).
447
Model Code Page
31. CareTel
1. 4. 1997
6000--8750 360 7
F. Query from special tracking log
The measuring values, which are gathered in the special tracking log, are initiated with ST message.
To Next Page
Loading...
Need help?
General
